Centurion VECTOR2 Installation Manual download pdf (Page 52)

22. Setting up Additional Features

Figure 69 provides the full menu of features that can be set up on the system.

An explanation of each feature is provided in the section ‘Controller Features’.

When setting up the VECTOR2 system via the LCD display, all the steps that have to be

followed are clearly provided via the display. It is only necessary to note the following:

1. To get into Setup Mode, press the ( ) button for three seconds and follow the

instructions provided from there.

2. The buttons provided on the controller for navigating the system are not marked

because at each step during the Setup, the function given to each button is provided

on the display.

Page 48

FIGURE 74. VIEW OF CONTROLLER

3. When not in Setup Mode, i.e. Normal Mode, the ( ) button is used as a test button

for operating the system. The up/down buttons are not used unless the diagnostic

screens have been selected to appear in Normal Mode, in which case these buttons

allow switching from one screen to the next.

For each feature a Factory Default setting has been programmed into the

controller. Referred to as an Operating Standard, these defaults have been

determined to suit the requirements of the specific region where the installa-

tion is being carried out. It is only necessary to change a feature where the

default does not suit the installation. When selecting any feature in the menu,

details of the current setting stored in the controller are displayed.

Refer to Table 1 on page 63 for the Schedule of Factory Defaults for each feature.

Menu LevelMenu LevelMenu Level

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 81 82

No comments

Centurion VECTOR2 Installation Manual Page 52